Response SA1 E Istruzioni per gli Interventi Scaricare il pdf (Pagina 17)

If your system includes PIR Detectors:

8. Arm the system in Instant-Arm mode by pressing

on the Remote Control.

The Siren will acknowledge the signal by beeping once,

(unless Beep Disable has been selected).

9. Ensure that the area protected by the PIR has been

free from movement for at least 2 minutes and then

walk into the area to trigger the detector

Note: To conserve power the PIR will only detect

movement if there has been no movement detected

within the previous 2 minutes.

10. Stop the alarm and Disarm the system by pressing

on the Remote Control.

The Siren will stop and acknowledge the signal

by beeping twice, (unless Beep Disable has been

selected).

11. Continue to test all PIR Detectors in turn as

described above, (steps 8 - 10).

If your system includes Magnetic Contact

Detectors:

12. Arm the system in Instant-Arm mode by pressing

the button on the Remote Control.

13. Open a door/window protected by a Magnetic

Contact Detector and ensure that the alarm sounds.

14. Disarm the system and stop the Siren by pressing

the button on the Remote Control.

15. Test each Magnetic Contact Detector in turn as

described above, (steps 12 - 14).

When leaving the premises, the system must be

Armed. However, before doing so, check that all

windows are closed and locked, all protected doors are

closed and PIR Detectors are not obstructed. Ensure

that pets are restricted to areas not protected by PIR

Detectors.

The system has 2 armed modes, Instant-Arm and

Delay-Arm.

Instant-Arm mode will immediately Arm the system.

Once the system is Armed, activating any detector,

(i.e. opening a door/windows protected by a Magnetic

Contact Detector or moving into a PIR protected area),

will immediately trigger an Alarm. On returning to and

entering the property the system must be Disarmed

before opening any protected door or entering an area

protected by a PIR Detector otherwise an Alarm will

occur. For this reason when using Instant-Arm mode,

the system should be Armed and Disarmed from

outside the property using the Remote Control.

Delay-Arm mode will Arm the system with a 15 second

entry/exit delay. On arming the system in Delay-Mode

the siren will beep once and then again after the 15

second delay has expired. This allows time for you to

leave the property before the system becomes fully

Armed. On returning to and entering the property by

opening a protected door or moving through a PIR

protected area the system will be triggered and the

Siren will emit a single long beep. However, an Alarm

will not sound until the 15 second delay has expired.

The system must be Disarmed using either the Remote

Control or Keypad during the 15 second delay to

prevent the Alarm from sounding.

If an Alarm occurs the Siren will sound continuously

until the set alarm duration time expires. The alarm

will then stop and the system will automatically re-arm

itself. This process can be repeated up to 3 times after

which time the “Alarm Lockout” feature will operate and

prevent the system from re-arming.

Notes: - To conserve power and maximise battery life

the PIR Detector will only detect movement if there

has been no movement detected within the previous 2

minutes.

- The system can only be armed if the Siren is in

Operating Mode, (see page 19).

OPERATING INSTRUCTIONS

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24

Commenti su questo manuale

Nessun commento

Response SA1 E Istruzioni per gli Interventi Pagina 17

Commenti su questo manuale

Prodotti e manuali riguardandi Sistemi di controllo di accesso Response SA1 E