Response RE3000S Istruzioni per gli Interventi Scaricare il pdf (Pagina 10)

REMOTE CONTROL(S)

One Remote Control Unit is supplied in the standard

RE5000S package. However, additional Remote

Control Unit(s) can be purchased separately, if

required. The Remote Control Unit(s) are used to Arm

and Disarm the System.

The Remote Control Unit also incorporates a personal

attack button. This sounds the alarm at any time

whether the system is Armed or not. Just press

and the alarm will sound. If this is activated

by mistake you can cancel the alarm by pressing and

releasing the “Disarm” button on the Remote Control.

Any number of Remote Control Unit(s) can be used

with your system, providing they are all coded with

the system ‘House Code’. To set the ‘House Code’

and fit the battery, proceed as follows.

1. Remove the fixing screw from the back of the

Remote Control Unit and carefully separate the

two halves of the unit.

2. Fit the 12 Volt Alkaline battery supplied with the

negative (-) towards the battery spring.

3. Set miniature switches 1-6 to a random combination

‘+’, ‘o’ or ‘-’ settings. This is your ‘House Code’.

Make a careful note of the setting of each switch

as this information will be needed when you set

up other items in your system.

Note: miniature switches 7 and 8 do not form part

of the ‘House Code’ and should be set in the

‘-’

position in the Remote Control.

Take care not to touch the printed circuit board or

allow dust or moisture to enter the Remote Control

Unit, as this may damage the electronic components.

4. Reassemble the two halves of the unit and secure

using the fixing screw.

SETTING THE CONTROL

UNIT HOUSE CODE

To enable the Control Unit to receive the radio signals

from your Remote Control(s) and Detectors, the

system ‘House Code’ must be programmed into the

Control Unit’s memory. The Control Unit learns the

system ‘House Code’ from the Remote Control.

Ensure that a battery has been fitted and a ‘House

Code’ has been set in the Remote Control and then

proceed as follows:-

1. Ensure that only the Control Unit’s top green mains

power indicator LED is illuminated.

2. Enter . The

Control

Unit is now in programming Mode. The Full Arm

and Part Arm LED’s will now be illuminated and all

the Zone LED’s will flash.

Enter . The Zone LED’s will extinguish.

(Unless a ‘House Code’ has already been set in

which case the LED’s will indicate the code set).

4. To set the Control Unit ‘House Code’, (or to change

the ‘House Code’ to the new code) simply press the

Disarm (Blue) button on your Remote Control.

8 RE5000S Professional Alarm System

View Inside Remote Control

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 33 34

Commenti su questo manuale

Nessun commento

Response RE3000S Istruzioni per gli Interventi Pagina 10

Commenti su questo manuale