Response SL8 Manuale delle Istruzioni Scaricare il pdf (Pagina 15)

POSITIONING THE DOOR/WINDOW

DETECTORS

The

Door/Window

Detector is suitable for mounting in

dry interior locations only.

ecide which doors and windows are to be protected

y fitting

oor / Window

etectors, (usually the front

nd back doors as a minimum will have

oor/Window

etectors fitted). However additional detectors may

e fitted where required to other more vulnerable

oors or windows, (e.g. garage, patio/conservatory

doors etc).

Ensure that the position selected for the

Door/Window

Detector is within effective range of

the Control Panel.

Do not fix the Detector onto or very close to

metalwork (i.e. radiators, water pipes, etc) as this

could affect the radio range of the device.

On PVC door/window frames, it may be necessary to

space the Detector and Magnet away from the metal

surface using a plastic or wooden spacer to achieve

the necessary radio range.

INSTALLING AND CONFIGURING THE

DOOR/WINDOW DETECTORS

1. Remove the battery cover by sliding and lifting it

off. (DO NOT use a screwdriver to lever it off).

2. Slide the two batteries supplied into the battery

holder, ensuring that the

side is uppermost on

each battery as it is installed.

3. If necessary, refit the battery holder into the

detector ensuring that the spring clip connectors

slide onto either side of the circuit board.

The Detector should be mounted on the fixed part

of the frame and the magnet on the opening part.

The Detector and Magnet should be mounted

using the double sided adhesive pads or screws

provided.

Note: If mounting the device using the adhesive

pads, ensure that the mounting surfaces are

clean and dry before mounting.

If fixing the detector with screws first remove

the battery holder by carefully tilting up the

end and pulling away from the printed circuit

board (PCB).

The top of the Detector is secured by hanging

the keyhole slot over the head of the 10mm pan

head screw. The bottom of the Detector is

secured using the 12mm counter-sunk head

screw fitted within the battery compartment.

Carefully drill out the centre of the fixing screw

hole in the battery compartment using a 3mm

drill. Fit the Magnet using the two 15mm fixing

screws. Do not over-tighten the screws as this

may distort or damage the casing.

5. If an additional wired Magnetic Contact is

required, this should be wired to the terminal

block provided in the battery compartment.

Double Sided Tape

OR Screw Fixing

Raised Head Screw,

Key-hole Slot Fixing

Small Counter-sunk

Screw Fixing

Slide Open and Lift Off

Do Not Use A Screwdriver

Battery

Connector

Tilt and Remove

Battery Holder

and Insert

Two Batteries

Fit TWO

Batteries

Detector

Magnet

Alternative

Mountings

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 39 40

Commenti su questo manuale

Nessun commento

Response SL8 Manuale delle Istruzioni Pagina 15

Commenti su questo manuale

Prodotti e manuali riguardandi Sistemi di controllo di accesso Response SL8